Filter
Top Products
30 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Printer Operation
Load Roll Media
Liner Take-Up Mode
The Liner Take-up option must be installed to use this mode. The option is shown in
Figure 18.
Figure 18 • Liner Take-Up Mode
To load media in Liner Take-Up Mode, complete these steps:
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide the media guide as far from the maim frame as possible.
4. Place a roll of media onto the media supply hanger as shown.
Note • This option is available on the Z4Mplus printer only
1
Printhead Assembly
2
Transmissive Sensor
3
Label Supply Guide
4
Label Supply Hanger
5
Liner Take-Up
6
Dancer
7
Label Guide
8
Printhead Open Lever
9
Peel Assembly
10
Label
11
Peel Lever
12
Tear-Off/Peel-Off Bar
1
2
3
4
5
6
7
8
9
10
11
12
Caution • Ensure that the printhead is fully open and engaged in the upright position.
If you fail to latch the printhead, it could fall on your hand during the procedure.