Filter
Top Products
50 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Configuration
Overview
Overview
After you have installed the media and ribbon and the Power-On Self Test (POST) is complete
(see Power-On Self Test on page 95 for more information), the front panel displays
PRINTER
READY
. Use the front panel display and the four keys directly below it to set printer
parameters for your application.
Enter Configuration Mode
To enter configuration mode, complete these steps:
1. From the front panel, press SETUP/EXIT:
2. Press PLUS (+) or MINUS (–) to scroll to the setting you wish to change.
3. Press SELECT to toggle the functionality of PLUS (+) and MINUS (–) keys.
4. Press PLUS (+) or MINUS (–) to increase or decrease the value, answer yes or no, print a
label, or select the digit you wish to change.
5. Press SELECT again to use PLUS (+) and MINUS (–) to scroll to the desired menu item.
Note • Printers that are operating on an IP network can be quickly configured in the following
ways:
• with the ZebraLink™ WebView (ZebraNet
®
PrintServer II required). For information, see
the ZebraNet Networking: PrintServer II Installation and User Guide.
• with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For
information, see the ZebraNet Wireless Print Server User Guide.
Note • An asterisk (*) in the upper left-hand corner of the display indicates that the value
displayed is different than the currently stored value.