Filter
Top Products
Configuration
Configuration and Calibration LCD Displays
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 67
Selecting Prefix and Delimiter Characters (next three parameters)
Prefix and delimiter characters are 2-digit hex values used within the ZPL/ZPL II formats sent to the printer.
The printer uses the last prefix and delimiter characters sent to it, whether from a ZPL II instruction or from the
front panel.
Do not use the same hex value for the control, format, and delimiter characters. The printer must see different
characters to function properly.
CONTROL PREFIX
Control Prefix Character
The printer looks for this 2-digit hex character to indicate the start of a ZPL/ZPL II
control instruction.
Default: 7E (tilde - displayed as a black square)
Range: 00 to FF
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
FORMAT PREFIX
Format Prefix Character
The printer looks for this 2-digit hex character to indicate the start of a ZPL/ZPL II
format instruction.
Default: 5E (caret)
Range: 00 to FF
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
DELIMITER CHAR
Delimiter Character
The delimiter character is a 2-digit hex value used as a parameter place marker in
ZPL/ZPL II format instructions. See the ZPL II Programming Guide Volume I for more
information.
Default: 2C (comma)
Range: 00 to FF
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value of the selected digit.
3. Press MINUS (–) to move to the next digit.
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters and Other LCD Displays (Sheet 11 of 15)
Parameter Action/Explanation