Filter
Top Products
Configuration
Configuration and Calibration LCD Displays
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 69
BACKFEED
Backfeed Sequence
This parameter establishes when and how much label backfeed occurs after a label is
removed or cut in the peel-off or cutter modes. It has no effect in rewind or tear-off
modes. This parameter setting can be superseded by the
~JS instruction when
received as part of a label format (see the ZPL II Programming Guide Volume I).
The difference between the value entered and 100% establishes how much backfeed
occurs before the next label is printed. For example, a value of 40 means that 40% of
the backfeed takes place after the label is removed or cut. The remaining 60% takes
place before the next label is printed. A value of “before” means that all backfeed takes
place before the next label is printed.
Default: Default (90%)
Selections: Default, after, before, 10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%, off
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
LABEL TOP
Adjusting Label Top Position
The label top position adjusts the print position vertically on the label. Positive numbers
adjust the label top position further down the label (away from the printhead); negative
numbers adjust the position up the label (toward the printhead).
Default: +0
Range: –120 to +120 dot rows
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value. The displayed value represents dots.
3. Press MINUS (–) to decrease the value.
4. Press SELECT to accept any changes and deselect the parameter.
LEFT POSITION
Adjusting Left Position
This parameter establishes how far from the left edge of a label the format begins to
print by adjusting horizontal positioning on the label. Positive numbers adjust the
printing to the left by the number of dots selected; negative numbers shift printing to the
right.
Default: 0000
Range: –9999 to +9999
1. Press SELECT to select the parameter.
2. Press MINUS (–) to move to the next position.
3. Press PLUS (+) to change between +/– or to increase the value of the digit. The
displayed value represents dots. For a negative value, enter the value before
changing to the minus sign.
4. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters and Other LCD Displays (Sheet 13 of 15)
Parameter Action/Explanation