Filter
Top Products
Printer Operation
Print a Configuration Label
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 43
Print a Configuration Label
Print a configuration label to test the printer setup. Do this when the printer is first installed, or
when the printer cannot properly detect the top of the label.
To print a configuration label, complete these steps:
1. Turn the printer power Off (O).
2. Press and hold CANCEL while turning the printer On (l). See Figure 3, Front Panel
Controls and LEDs, on page 3.
3. Release CANCEL after the DATA light turns off (approximately five seconds).
A configuration label prints showing the printer’s currently stored parameters (similar to
the labels shown in Figure 28).
Figure 28 • Sample Configuration Labels
Z6Mplus - 300dpi
4
4
Z4Mplus - 200dpi