Filter
Top Products
Printer Operation
Load Roll Media
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 35
Rewind Mode
The Rewind option must be installed to use this mode. The option is shown in Figure 23.
Figure 23 • Rewind Mode
To load media in Rewind Mode, complete these steps:
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide the media guide as far from the main frame as possible.
4. Place a roll of media on the media supply hanger as shown.
1
Printhead Assembly
2
Transmissive Sensor
3
Label Supply Guide
4
Label Supply Hanger
5
Rewind Spindle
6
Rewind Label Guide
7
Thumbscrew
8
Dancer
9
Label Guide
10
Media Alignment Spindle
11
Printhead Open Lever
12
Rewind Base Assembly
13
Peel Assembly
14
Peel Lever
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Caution • Ensure that the printhead is fully open and engaged in the upright position.
If you fail to latch the printhead, it could fall on your hand during the procedure.