Filter
Top Products
28 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Printer Operation
Load Roll Media
Peel-Off Mode
This setting works only with the Peel-Off Option installed on the printer. Figure 17 shows the
printer with the Peel-Off Option.
Figure 17 • Peel-Off Mode
To load media in Peel-Off Mode, complete these steps:
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide the media guide as far from the printer main frame as possible.
4. Place a roll of media onto the media supply hanger as shown.
5. Flip up the media supply guide.
6. Slide in the media supply guide until it just touches, but does not restrict, the edge of the
media.
1
Printhead Assembly
2
Transmissive Sensor
3
Media Supply Guide
4
Media Supply Hanger
5
Dancer
6
Media Guide
7
Printhead Open Lever
8
Peel Assembly
9
Label
10
Peel Lever
11
Tear-Off/Peel/Off Bar
2
1
3
4
5
6
7
8
9
101
11
Caution • Ensure that the printhead is fully open and engaged in the upright position.
If you fail to latch the printhead, it could fall on your hand during the procedure.