Filter
Top Products
58 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Configuration
Configuration and Calibration LCD Displays
TEAR OFF
Adjusting the Tear-Off Position
This parameter establishes the position of the media over the tear-off/peel-off bar after
printing. The label and liner can be torn off or cut between labels.
Default: +0
Range: –120 to +120
1. Press SELECT to select the parameter.
2. Press PLUS (+) to increase the value. Each press adjusts the tear-off position by
four dot rows.
3. Press MINUS (–) to decrease the value.
4. Press SELECT to accept any changes and deselect the parameter.
PRINT MODE
Selecting Print Mode
Print mode settings tell the printer the method of media delivery that you wish to use.
Be sure to select a print mode that your hardware configuration supports as some
selections displayed are for optional printer features.
Default: Tear-off
Selections: Tear-off, cutter, peel-off, rewind
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
MEDIA TYPE
Setting Media Type
This parameter tells the printer the type of media you are using. Selecting continuous
media requires that you include a label length instruction in your label format
(
^LLxxxx if you are using ZPL or ZPL II).
When non-continuous media is selected, the printer feeds media to calculate label
length (the distance between two detections of the inter-label gap, webbing, or
alignment notch or hole).
Default: Non-Continuous
Selections: Non-Continuous, Continuous
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
SENSOR TYPE
Setting the Sensor Type
This parameter tells the printer whether you are using media with a web (gap or space
between labels, notch, or hole) to indicate the separation between labels or if you are
using media with a black mark printed on the back. If your media does not have black
marks on the back, leave your printer at the default setting (web).
Default: Web
Selections: Web, mark
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (–) to display other choices.
3. Press SELECT to accept any changes and deselect the parameter.
Table 9 • Printer Parameters and Other LCD Displays (Sheet 2 of 15)
Parameter Action/Explanation