Filter
Top Products
Chapter 9 VLAN
XGS-4526/4528F/4728F User’s Guide
127
9.7 Configuring Subnet Based VLAN
Click Subnet Based VLAN in the VLAN Port Setting screen to display the
configuration screen as shown.
Note: Subnet based VLAN applies to un-tagged packets and is applicable only when
you use IEEE 802.1Q tagged VLAN.
Figure 44 Advanced Application > VLAN > VLAN Port Setting > Subnet Based
VLAN
The following table describes the labels in this screen.
Table 20 Advanced Application > VLAN > VLAN Port Setting > Subnet Based VLAN
Setup
LABEL DESCRIPTION
Active Check this box to activate this subnet based VLANs on the Switch.
DHCP-Vlan
Override
When DHCP snooping is enabled DHCP clients can renew their IP address
through the DHCP VLAN or via another DHCP server on the subnet based
VLAN.
Select this checkbox to force the DHCP clients in this IP subnet to obtain
their IP addresses through the DHCP VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Active Check this box to activate the IP subnet VLAN you are creating or editing.
Name Enter up to 32 alphanumeric characters to identify this subnet based VLAN.