Filter
Top Products
Chapter 35 Policy Routing
XGS-4526/4528F/4728F User’s Guide
325
35.2.1 Policy Routing Rule Configuration
You must first configure a layer-3 classifier in the Classifier screen (see Section
20.2 on page 201) and a policy routing profile in the Policy Routing screen (see
Section 35.2 on page 324).
Use this screen to configure a policy route to override the default (shortest path)
routing behavior and forward packets based on the classifier and action you
specify. A policy route rule defines the matching classifier and the action to take
when a packet meets the criteria in the classifier. The action is taken only when all
the criteria are met. Policy-based routing is applied to incoming packets on a per
interface basis before normal routing. The Switch does not perform normal routing
on packets that match any of the policy routes.
Click Rule Configuration in the IP Application > Policy Routing screen to
display the screen as shown.
Figure 157 IP Application > Policy Routing > Rule Configuration