Filter
Top Products
Chapter 26 IP Source Guard
XGS-4526/4528F/4728F User’s Guide
276
26.6.2 ARP Inspection Log Status
Use this screen to look at log messages that were generated by ARP packets and
that have not been sent to the syslog server yet. To open this screen, click
Advanced Application > IP Source Guard > ARP Inspection > Log Status.
Figure 125 ARP Inspection Log Status
The following table describes the labels in this screen.
Table 85 ARP Inspection Log Status
LABEL DESCRIPTION
Clearing log status
table
Click Apply to remove all the log messages that were generated
by ARP packets and that have not been sent to the syslog server
yet.
Total number of logs This field displays the number of log messages that were
generated by ARP packets and that have not been sent to the
syslog server yet. If one or more log messages are dropped due
to unavailable buffer, there is an entry called overflow with the
current number of dropped log messages.
Index This field displays a sequential number for each log message.
Port This field displays the source port of the ARP packet.
VID This field displays the source VLAN ID of the ARP packet.
Sender Mac This field displays the source MAC address of the ARP packet.
Sender IP This field displays the source IP address of the ARP packet.
Num Pkts This field displays the number of ARP packets that were
consolidated into this log message. The Switch consolidates
identical log messages generated by ARP packets in the log
consolidation interval into one log message. You can configure
this interval in the ARP Inspection Configure screen. See
Section 26.7 on page 277.