Filter
Top Products
Chapter 46 Access Control
XGS-4526/4528F/4728F User’s Guide
408
Get Community Enter the Get Community string, which is the password for the
incoming Get- and GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using
SNMP version 2c or lower.
Set Community Enter the Set Community, which is the password for incoming Set-
requests from the management station.
The Set Community string is only used by SNMP managers using
SNMP version 2c or lower.
Trap
Community
Enter the Trap Community string, which is the password sent with
each trap to the SNMP manager.
The Trap Community string is only used by SNMP managers using
SNMP version 2c or lower.
Trap
Destination
Use this section to configure where to send SNMP traps from the Switch.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps
to.
Port Enter the port number upon which the manager listens for SNMP traps.
Username Enter the username to be sent to the SNMP manager along with the
SNMP v3 trap.
Note: This username must match an existing account on the Switch
(configured in the Management > Access Control > SNMP
> User screen).
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 151 Management > Access Control > SNMP (continued)
LABEL DESCRIPTION