Filter
Top Products
Chapter 44 Load Sharing
XGS-4526/4528F/4728F User’s Guide
388
The following table describes the labels in this screen.
Table 140 IP Application > Load Sharing
LABEL DESCRIPTION
Active Select this option to enable Equal-Cost MultiPath (ECMP) routing on the
Switch.
Criteria Select the criteria the Switch uses to determine the routing path for a
packet.
Select src-ip to have the Switch use a hash algorithm to convert a packet’s
source IP address into a hash value which acts as an index to a route path.
Select src-dst-ip to have the Switch use a hash algorithm to convert a
packet’s source and destination IP addresses into a hash value which acts
as an index to a route path.
Aging Time Specify the time interval (from 0 to 86400 in increments of 10) in seconds
at which the Switch sends an ARP request to update a resolved next-hop’s
MAC address.
Discover
Time
Specify the time interval (from 0 to 86400 in increments of 10) in seconds
at which the Switch sends an ARP request to update an unresolved next-
hop’s MAC address.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.