Filter
Top Products
3-14 CHAPTER 3: WINDOWS NT DRIVER INSTALLATION
To configure NICs and ELANs, follow these steps:
1 Select the NIC that you want to configure from the
ATMLink NIC list box in the ATMLink Installation window.
You can configure the NICs in any order that you wish.
2 To make the selected NIC a standby NIC, select one or
more active NICs.
Eligible active NICs appear in the Resilient Server Link box.
If you make a NIC a standby NIC, no further configuration is
necessary. Proceed to step 7.
ELAN Parameters (specific to each ELAN)
ELAN Name 0- to 32-character
ASCII string
ELAN names must match ELAN names
configured on the ATM switch. ELAN
names are case-sensitive.
Traffic Shaping 1–155 Mbps Sets the maximum bandwidth available
to an ELAN.
LE Configuration
Mode
Automatic using
ILMI
Automatic with
specific LECS
Manual with specific
LES
Select Automatic using ILMI for ILMI
service.
Select Automatic with specific LECS to
connect with a LECS different from that
specified by ILMI.
Select Manual with a specific LES to
bypass the LECS and connect directly
with a LES of known address.
LECS ATM Address ATM Forum
Well-known Address
Enter the 20-byte network address of
the target LECS if it does not use the
ATM Forum Well-known Address.
LES ATM Address No default Enter the 20-byte network address of
the target LES.
Table 3-1 3C975 ATMLink NIC Installation Configuration Parameters (continued)
Field
Range of Values
(Defaults in Bold)
Description