Filter
Top Products
3-24 CHAPTER 3: WINDOWS NT DRIVER INSTALLATION
Adding SNMP Support
The SNMP agent shipped with the ATMLink NIC offers limited
support for the ATM Forum LAN Emulation Client Management
Version 1.0 Specification. The agent is shipped on the
ATMDisk diskette as the LECMIB.DLL and LECIFMIB.DLL files, for
use with Windows NT only. The files are automatically copied
to the system hard drive during driver installation and install
themselves if Windows NT is running the SNMP service. If the
SNMP service was not running when the agent was copied
from the ATMDisk diskette, the agent must be manually
installed.
The ATMLink SNMP agent responds to requests from any
standard SNMP network management software. The SNMP
Get and GetNext commands work for all the LEC MIB objects.
The Set command does not work with all SNMP variables,
and the user cannot create or modify an LEC.
To manually install the ATMLink SNMP agent on your
Windows NT system, perform the following procedure:
Make sure that the SNMP service is installed on Windows NT.
See your Microsoft WIndows NT Installation Guide for more
information.
1 Perform steps 1 through 9 of the Windows NT driver
installation procedure described in the section “Installing
the Network Driver.”
2 From the Select OEM Option dialog box, select
3Com ATMLink SNMP LEC MIB Agent, as shown in Figure 3-16.