Filter
Top Products
3Com Router 5000 and Router 6000 v2.41
Module Guide
Chapter 2 Smart Interface Cards
2-2
being received or/and transmitted.
2.1.2 Interface Cable
Normally, category-5 twisted pair cable is adopted to connect the 10BASE-T
/100BASE-TX Ethernet interface to the Ethernet, as shown in the following figure:
Figure 2-2 Ethernet cable
Ethernet cables fall into two categories: straight-through cables and crossover cables,
specifically,
z Straight-through cable: the wire sequences of the twisted pair cable crimped in
the RJ-45 connectors at both ends are completely the same. It is used to connect
terminal devices (such as PCs, routers) to Hubs or LAN Switches.
z Crossover cable: The wire sequences of twisted pair cable crimped in the RJ-45
connectors at both ends are different. It can be used to connect two terminal
devices (such as PCs and Routers). You can such kind of cables by yourself if
necessary.
2.1.3 Connecting the Interface Cable
If the SIC has been properly installed, follow these steps to connect the interface
cable:
Step 1: Connect the Ethernet port of SIC to a PC or router using a crossover cable and
to a Hub or LAN Switch using a straight-through cable;
Step 2: Power on the Router and check the SLOT1 LED on its front panel: ON means
that the SIC is operating normally and OFF means that the Power-On Self-Test (POST)
of the SIC has failed. In the latter case, please contact your agent.
Step 3: Check the status of LINK LED on the panel: ON means the link is connected
and OFF means the link is not connected. In the latter case, check the line.