Filter
Top Products
2-6 C
HAPTER
2: B
RIDGING
AND
IP
Configuring a Unit using the “Quick Configuration” Utility
If the central site unit has been configured, the Quick Configuration
utility can be used at the remote site to configure the remote site
unit.
Assign the Unit Name, IP Address and Subnet Mask
The remote unit must be assigned a unique name and a valid, unique
IP address appropriate to the IP network environment. The name and
IP address must exactly match the entries in the central site unit’s
ISDN Numbers and ISDN Autocall tables for this remote unit. Set the
ISDN network type to match the ISDN service.
1
Enter
QC
NA
to display the Unit Parameters screen.
2
Type the unique name for the unit in the Unit Name field. It can have
up to 12 characters. Do not include spaces in the unit name.
3
Type a valid IP address for the unit in the Unit LAN IP Address field.
4
Toggle the Network Type field to the correct ISDN network type using
the Spacebar, if required.
5
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Connect to an IP Network
It is important that the central site unit, to which the remote unit will
connect at the completion of this section, has been correctly
configured prior to the connection.
1
Enter
QC
IPB
to display the Connect To The Same IP Network screen.
2
Type the number of the
central site unit
in the ISDN number of the
remote unit you want to call field.
3
Type the IP address of the central site unit in the IP Address of the
remote host field.
4
Press [Ctrl]+[E] to submit the new setting.
If the ISDN line has been correctly connected to the units and is
functioning correctly, an automatic call is made to the central site
unit which allows both units to add new entries to their ISDN
Numbers and ISDN Autocall tables.
Get_con.bk : BRID_IP.FRM Page 6 Friday, October 3, 1997 1:49 PM