Filter
Top Products
Manual Configuration of a Central Site Unit for Routing IP 3-3
Manual Configuration of a Central Site Unit for Routing IP
If the central site unit is being configured for the first time, or if it is
an entirely new installation, then reset the unit to the factory default
settings by entering CO STD
CAUTION:
Do not reset the unit if has already been installed on the
network and configured to bridge or route IPX, and is required to
continue bridging or routing IPX
.
CAUTION:
If the unit has already been configured, and it is
necessary to keep some of the settings, take a note of the current
configuration settings and port type and put it in a safe, accessible
place.
If the central site unit is being configured for the first time, or if it is
an entirely new installation, then reset the unit to the factory default
settings.
1
Press the [Return] key.
2
Enter PASSWORD (in upper-case letters) when the Enter Password
screen is displayed.
3
Enter CO STD
4
Do you wish to keep IP Addresses and ISDN parameters.
KEEP (Y/N)? is displayed at the command line. Enter N
5
This will ERASE all configurations. ERASE (Y/N) is
displayed. Enter Y
6
System will now reboot is displayed.
7
Follow the on-screen instructions.
8
Enter PASSWORD when the Enter Password screen is displayed.
9
Enter SAVE and then enter QUIT
10
Power-cycle the unit by removing and then refitting the power lead.
11
Follow the on-screen instructions.
12
Enter PASSWORD when the Enter Password screen is displayed.
Following the above sequence will ensure that the unit is reset to the
factory default configuration and that the unit database is empty.
Get_con.bk : ROUT_IP.FRM Page 3 Friday, October 3, 1997 1:49 PM