Filter
Top Products
2-10 C
HAPTER
2: B
RIDGING
AND
IP
3
Type the name assigned to the remote unit in the Remote Unit field.
Unit names are case-sensitive and must be entered correctly.
4
Type the IP address assigned to the remote unit in the IP Address
field.
5
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Establish a Remote Management Session
A manual call must be placed before the remote configuration of the
remote unit can proceed.
1
Enter
CO
IS
NU
to display the ISDN Numbers table.
2
Select the entry for the remote unit using the Arrow keys and enter
CALL
3
Enter
REM
to display the Remote Units screen. Press [Ctrl]+[V] at
regular intervals to refresh the screen, until an entry for
NoName
10.0.0.1
appears.
4
Select the
NoName
10.0.0.1
entry using the Arrow keys and enter
REM
5
The Enter Password screen on the remote unit should be displayed
within 30 seconds.
■
If the Enter Password screen is not displayed, check that the name
and IP address for the remote unit have been entered correctly on
the central site unit and that the ISDN line is connected and
working normally at both ends of the link.
6
Enter
PASSWORD
(in upper-case letters) when the Enter Password
screen is displayed.
Configuring the Remote Site Unit
Assign the Unit Name
1
Enter
CO
SYS
to display the System Parameters screen.
2
Type in the name assigned to the unit in the Unit Name field. The
name must be exactly the same as that used to configure the entry
for this unit in the central site unit ISDN Numbers table.
Get_con.bk : BRID_IP.FRM Page 10 Friday, October 3, 1997 1:49 PM