Filter
Top Products
Configuring a Remote Unit from the Central Site 5-11
Configure the ISDN Numbers Table on the Central Site Unit
Set up the ISDN numbers table to associate the name which the remote
unit will have
once it has been configured,
with the ISDN number.
1
Enter CO IS NU to display the ISDN Numbers screen.
2
Enter ADD to add a new entry to the numbers table.
3
Type the name that the
remote
unit will have in the Name field.
4
Type the ISDN number for the remote unit in the ISDN Number 1
field.
It is very important to remember that Novell IPX routing uses
numbered
links. This means that the ISDN line between this unit and a remote site
represents an additional Novell IPX network and has to be assigned a valid
Novell IPX network number.
5
Type the IPX network address of the
numbered link
in the IPX
Network field, not the IPX network address of the remote unit.
6
Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Establish a Remote Management Session
A manual call must be placed before the remote configuration of the
remote unit can proceed.
1
Enter CO IS NU to display the ISDN Numbers table.
2
Highlight the entry for the remote unit and enter CALL
3
Enter REM to display the Remote Units screen. Press [Ctrl]+[V] at regular
intervals to refresh the screen, until an entry for NoName 10.0.0.1
appears.
4
Select the NoName 10.0.0.1 entry using the Arrow keys and enter
REM
5
The Enter Password screen on the remote unit should be displayed
within 30 seconds.
■
If the Enter Password screen is not displayed, check that the name
and IP address for the remote unit have been entered correctly on
the central site unit and that the ISDN line is connected and
working normally at both ends of the link.
Get_con.bk : IPX_ROUT.FRM Page 11 Friday, October 3, 1997 1:49 PM