Filter
Top Products
5-10 C
HAPTER
5: N
OVELL
IPX R
OUTING
CAUTION:
Prior to despatch, it is essential that the unit has the ISDN
Network Type field configured to match the ISDN network type at
the remote site.
Prior to Despatch
Power on the unit and follow the sequence of steps for resetting the
unit to the factory default configuration, as described in
“Configuring a Central Site Unit for Routing IPX” on page 5-2.
Configure the ISDN network type to the correct setting for the
remote site, following the sequence of steps described in “Configure
the ISDN Network Type” on page 5-4.
When the unit is received at the remote site, ensure that it is
powered on and that the ISDN Port is connected to a correctly
functioning ISDN line, using the supplied ISDN cable.
Configuring the Central Site Unit
The central site unit must be correctly configured with the following
parameters:
■
Unit name (see page 5-3).
■
A valid IP address and subnet mask (see page 5-4).
■
The IPX network number (see page 5-4).
■
The IPX frame type (see page 5-4).
■
The correct ISDN network type (see page 5-4).
An existing central site IPX router only requires IPX routing to be
temporarily disabled and the remote site unit parameters to be
added to the ISDN Numbers table, prior to configuring the remote
unit.
Enable Novell RIP/SAP Learning
Novell RIP/SAP learning must be enabled at both ends of the link.
1
Enter
CO
BR
PA
to display the Filter Parameters screen.
2
Toggle the Learn Novell RIP/SAP field to
ENABLE
using the Spacebar.
3
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Get_con.bk : IPX_ROUT.FRM Page 10 Friday, October 3, 1997 1:49 PM