Filter
Top Products
Configuring a Central Site Unit for Routing IPX 5-3
configuration settings and port type and put it in a safe, accessible
place.
If the central site unit is being configured for the first time, or if it is
an entirely new installation, then reset the unit to the factory default
settings.
1
Press the [Return] key.
2
Enter PASSWORD (in upper-case letters) when the Enter Password
screen is displayed.
3
Enter CO STD
4
Do you wish to keep IP Addresses and ISDN parameters.
KEEP (Y/N)? is displayed at the command line. Enter N
5
This will ERASE all configurations. ERASE (Y/N) is
displayed. Enter Y
6
System will now reboot is displayed.
7
Follow the on-screen instructions.
8
Enter PASSWORD when the Enter Password screen is displayed.
9
Enter SAVE and then enter QUIT
10
Power-cycle the unit by removing and then refitting the power lead.
11
Follow the on-screen instructions.
12
Enter PASSWORD when the Enter Password screen is displayed.
Following the above sequence will ensure that the unit is reset to the
factory default configuration and that the unit database is empty.
Assign the Unit Name
The unit
must
be assigned a unique name. The unit software relies
on associating unit names with ISDN numbers for its core
functionality.
1
Enter CO SYS to display the System Parameters screen.
2
Type a unique name for the unit in the Unit Name field. It can have
up to 12 characters but note that the name is case-sensitive. Do not
include spaces in the unit name.
3
Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Get_con.bk : IPX_ROUT.FRM Page 3 Friday, October 3, 1997 1:49 PM