Filter
Top Products
4-8 C
HAPTER
4: N
OVELL
IPX
AND
B
RIDGING
It is good practise to have ensured that the remote unit was restored
to the factory default settings before being despatched to the
remote site.
CAUTION:
Prior to despatch, it is essential that the unit has the ISDN
Network Type field configured to match the ISDN network type at
the remote site.
Prior to Despatch
Power on the unit and follow the sequence of steps for resetting the
unit to the factory default configuration, as described in “Manual
Configuration of a Central Site Unit for Bridging and IPX” on
page 4-3.
Configure the ISDN network type to the correct setting for the
remote site, following the sequence of steps described in “Configure
the ISDN Network Type” on page 4-4.
When the unit is received at the remote site, ensure that it is
powered on and that the ISDN Port is connected to a correctly
functioning ISDN line, using the supplied ISDN cable.
Configuring the Central Site Unit
The central site unit must be correctly configured with the following
parameters:
■
Unit name (see page 4-4).
■
A valid IP address and subnet mask (see page 4-4).
■
The IPX network number (see page 4-4).
■
The IPX frame type (see page 4-4).
■
The correct ISDN network type (see page 4-4).
Get_con.bk : IPX_BRID.FRM Page 8 Friday, October 3, 1997 1:49 PM