Filter
Top Products
Configuring a Remote Unit from the Central Site 4-9
Configure the ISDN Numbers Table on the Central Site Unit
A new entry must be added to the ISDN Numbers table on the central
site unit, giving the name that the remote unit will have once that unit
has been fully configured, and the ISDN number for the unit.
1
Enter CO IS NU to display the ISDN Numbers screen.
2
Enter ADD to add a new entry to the numbers table.
3
Type the name
assigned to the remote unit
in the Name field and the
ISDN number for that unit in the ISDN Number 1 field.
Do not alter the IP Address, IP Mask or IPX Network fields.
Unit names are case-sensitive and must be entered correctly.
4
Press [Ctrl]+[E] to submit the new setting and then enter SAVE
Establish a Remote Management Session
A manual call must be placed before the configuration of the remote
unit can proceed.
1
Enter CO IS NU to display the ISDN Numbers table.
2
Select the entry for the remote unit using the Arrow keys and enter
CALL
3
Enter REM to display the Remote Units screen. Press [Ctrl]+[V] at regular
intervals to refresh the screen, until an entry for NoName 10.0.0.1
appears.
4
Select the NoName 10.0.0.1 entry using the Arrow keys and enter
REM
5
The Enter Password screen on the remote unit should be displayed
within 30 seconds.
■ If the Enter Password screen is not displayed, check that the name
and IPX network address for the remote unit have been entered
correctly on the central site unit and that the ISDN line is
connected and working normally at both ends of the link.
6
Enter PASSWORD (in upper-case letters) when the Enter Password
screen is displayed.
Get_con.bk : IPX_BRID.FRM Page 9 Friday, October 3, 1997 1:49 PM