Filter
Top Products
2-12 C
HAPTER
2: B
RIDGING
AND
IP
4
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Configure the ISDN Autocall Table
Set up the ISDN Autocall table to associate the central site unit IP
address with its name.
1
Enter
CO
IS
AUTO
IP
to display the ISDN IP Autocall Addresses
screen.
2
Enter
ADD
to add an entry to the ISDN IP Autocall table.
3
Type the name of the
central site
unit in the Remote Unit field. Ensure
that the name is correctly typed because this field is case-sensitive.
Unit names are case-sensitive and must be entered correctly.
4
Type the IP address of the
central site
unit in the IP Address field.
5
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Close the Remote Management Session
1
Enter
QUIT
to close the remote management session.
The Remote Units screen on the central site unit is displayed.
Cancel the Manual Call
It is important to remember that a manual call is still running from
the initial connection to the remote unit. The call must be cancelled
manually.
1
Enter
CO
IS
NU
to display the ISDN Numbers screen.
2
Select the entry for the remote site unit and enter
CANC
to cancel the
call.
3
Enter
SAVE
to save the new configuration.
All manual calls must be cancelled when the unit configuration is
complete. A “call guillotine” operates after 60 minutes (the default
setting) to cancel the calls but during this time, additional,
unnecessary, call charges will have accrued.
Get_con.bk : BRID_IP.FRM Page 12 Friday, October 3, 1997 1:49 PM