Filter
Top Products
Configuring a Remote Unit from the Central Site 5-15
made to allow the unit to receive NRIP and SAP updates being
advertised by the Novell IPX server at the central site.
1
Enter CO IS NU to display the ISDN numbers table.
2
Select the remote site unit entry using the Arrow keys and enter
CALL
3
Enter REM to display the Remote Units screen.
4
Select the remote site unit entry using the Arrow keys and enter REM
to establish a remote management session with the remote unit.
5
Enter PASSWORD when the Enter Password screen is displayed.
The manual call (which should last for approximately 10 minutes),
coupled with NRIP/SAP learning enabled, allows the IPX Autocall
table to be constructed automatically.
Enter CO IS AUTO IPX to monitor the construction of the IPX
Autocall table. Press [Ctrl]+[V] at intervals to refresh the display.
Wait until the entries in the IPX Autocall table screen have been
stable for several minutes.
If a specific server is required to respond to GNS requests, follow the
steps given in “Specific Server for 'Get Nearest Server' Responses” on
page 5-8.
6
Enter SAVE to save the new configuration.
7
Enter QUIT to cancel the remote management session.
8
Enter CO IS NU to display the ISDN numbers table on the central site
unit.
9
Select the entry for the remote site using the Arrow keys unit and
enter CANC
The manual call is not cancelled automatically; it must be cancelled
manually.
10
Enter SAVE to save the new configuration.
Get_con.bk : IPX_ROUT.FRM Page 15 Friday, October 3, 1997 1:49 PM