Filter
Top Products
3-12 C
HAPTER
3: R
OUTING
IP
It is important to enter static routes when configuring the unit to use
unnumbered links because these routes will not be learned by the
unit. Static routes must be entered at
both
ends of the link.
Set up the IP Routing table to associate an IP route with a unit name.
1
Enter
CO
RO
IP
to display the Configured IP Routes screen.
2
Enter
ADD
to display the Add Routing Table Entry screen.
3
Type the IP address of the remote LAN in the Target field.
4
Type a valid subnet mask for the remote network in the Subnet Mask
field.
5
Type the name of the remote unit in the Router field.
Unit names are case-sensitive and must be entered correctly.
6
Press [Ctrl]+[E] to submit the new setting and then enter
SAVE
Establish a Remote Management Session
A manual call must be placed before the remote configuration of the
remote unit can proceed.
1
Enter
CO
IS
NU
to display the ISDN Numbers table.
2
Select the entry for the remote unit using the Arrow keys and enter
CALL
3
Enter
REM
to display the Remote Units screen. Refresh the screen by
pressing [Ctrl]+[D] at regular intervals until an entry for
NoName
appears.
4
Select the
NoName
10.0.0.1
entry using the Arrow keys and enter
REM
5
The Enter Password screen of the remote unit should be displayed
within 30 seconds.
■
If the Enter Password screen is not displayed, check that the name
and IP address for the remote unit have been entered correctly on
the central site unit and that the ISDN line is connected and
working normally at both ends of the link.
6
Enter
PASSWORD
(in upper-case letters) when the Enter Password
screen is displayed.
Get_con.bk : ROUT_IP.FRM Page 12 Friday, October 3, 1997 1:49 PM