Filter
Top Products
Installation
Configuring the Test Software
Chapter 2
O:\Manuals\E6385A_Amps\Book\install.fm
38
Test Configuration
Before the Test Software can perform automated Base Station testing, it must have
available certain information regarding test conditions. Supply this information on the
Test Configuration Menu screen.
Configure the test as follows:
Step 1. Select the Test Configuration field. The Test Software will display the Test
Configuration Menu (see Figure 2-10).
Figure 2-10 Specifying Test Configuration Information
Step 2. Select the 8935 Reference Select field and select from the drop-down Choices: list to
match the type of frequency reference for the Test Set.
• Select Auto to use the Test Set internal timebase, unless an external reference signal
of sufficient amplitude is applied to the REF IN connector. If an external signal is
applied, the Test Set automatically switches to use that external reference. You must
then specify the external timebase frequency in the 8935 EXT Ref Frequency field.
• Select Internal to use the Test Set internal timebase always.
• Select External to use an external timebase, which must be connected to the REF IN
connector.
Step 3. If an external time base is to be used, select the 8935 EXT Ref Frequency field and
select the external timebase frequency from the drop-down Choices: list. The available
selections are: 1 MHz, 2 MHz, 5 MHz, 10 MHz, and 15 MHz.
Step 4. Select the Speaker Volume field and select from the drop-down Choices: list to set it to
the desired level. The available selections are: Off, Quiet, and Loud. (This setting
determines the volume of the beeps and tones issued by the Test Software during
operation.)
Step 5. Press the
k5 (Return) key to return to the Lucent AMPS Tests Main Menu screen.