Filter
Top Products
Installation
Defining a Frequency Plan
Chapter 2
O:\Manuals\E6385A_Amps\Book\install.fm
46
Step 8. Insert an initialized SRAM card into the Test Set front panel card slot, and press the
k3
(Store) key to store the plan. Store the plan using the Cell Site number entry.
Step 9. If you wish to define plans for other sites, repeat step 2 through step 8 for each site.
Otherwise, press
k5 (Return) to return to the Calibration/Utilities Menu.
Defining a Frequency Plan Using a PC
You may create a frequency plan using a PC and then download that plan to the Test Set.
A plan created using a PC may be saved, reused, and updated as necessary.
Requirements
❏ A PC with an available serial communications port.
❏ A PC program for text editing (such as Windows Notepad) and a program for serial
communications (such as the BTS Laptop Utility program shipped with the Test
Software).
❏ A null modem cable for connecting the Test Set to the PC.
❏ Optional – An initialized SRAM card for storing the frequency plans once defined.
Test Set to PC Connection
If you have not done so already, configure the PC to communicate with the Test Set (see
“Configuring the Test Set and PC Serial Ports for Communication with the Test Set” on
page 28).
Connect the Test Set and the PC for serial connection in the same manner the same as
that used for testing the radio with a connected PC (see Figure 2-17).
Figure 2-17 Test Set to PC Serial Connection
Laptop PC
COM DB9
Connector
Null Modem Cable
Test Set Side Panel
DB9 Connector
SERIAL 9
SERIAL 10
SERIAL 11
SERIAL 9