Filter
Top Products
System Operations 4
Network Settings
Agilent FrameScope Pro User’s Manual 109
The first Network Settings Setup screen
allows you to select PPoE or IP addressing.
• MAC Address - The MAC Address of
the FrameScope.
Usually it contains a value set in the
factory. But this field can be used to
change the MAC address if this is
necessary for a specific case or to
satisfy security requirements.
The MAC address can be reset to the
factory default on the next boot-up as
described in “Restoring the Default MAC Address” on
page 113.
PPPoE Settings If you select PPPoE, you
must also enter Username, Password and
Domain in the PPPoE Settings Screen, after
you press Next:
IP Settings You can select DHCP to
automatically configure the FrameScope
Pro when connected to the network, or
manually configure the IP address,
Gateway, Subnet Mask and other settings. If
you manually configure the IP settings, you
have to at least enter a valid IP address and
a valid subnet mask.
• IP Address – This value uniquely
identifies the FrameScope in the
TCP/IP network.
• Subnet Mask – This value is combined with the IP Address
to define the subnet to which the FrameScope belongs.
CAUTION
MAC address modification is not advisable.
If a modification is unavoidable, the changes
should be done with extreme care so that it
will not conflict with any MAC address that is
in use.
NOTE
PPPoE has no manual configuration of IP address,
Sub-net mask or default gateway.