Filter
Top Products
System Operations 4
Setting up the Optional Auxiliary Port
Agilent FrameScope Pro User’s Manual 119
To change the network settings of the
Auxiliary port, click on the edit button and
the Auxiliary port setup screen will appear.
• MAC Address - The MAC Address of
the FrameScope usually contains a
value set in the factory. But this field
can be used to change the MAC
address if this is necessary for a
specific case or to satisfy security
requirements.
The MAC address can be reset to the factory default on
the next boot-up by turning “Restore Default MAC” on in
the System Settings.
You can use DHCP to automatically configure the FrameScope
when connected to the network, or manually configure the IP
details. If you manually configure, you are required to at least
enter a valid IP address and a valid subnet mask.
• IP Address – This value uniquely identifies the
FrameScope in the TCP/IP network.
• Subnet Mask – This value is combined with the IP Address
to define the subnet to which the FrameScope belongs.
• Default Gateway – This is the default gateway (router) the
FrameScope will use to communicate with devices on
other subnets.
If you make changes, a pop-up will appear asking you to restart
the FrameScope Pro for the new settings to take affect.
CAUTION
MAC address modification is not advisable.
If a modification is unavoidable, the changes
should be done with extreme care so that it
will not conflict with any MAC address that is
in use.