Filter
Top Products
Network Testing with the FrameScope Pro 2
Performance Tests
Agilent FrameScope Pro User’s Manual 65
password. You will get a warning, “Permission Denied”, if a
password is set in the slave FrameScope and not entered
correctly in the master FrameScope.
8 Press Start to begin test.
After pressing the Start button, the master FrameScope
starts the activation and synchronization procedures with
the target FrameScope by doing the following actions:
9 Search (if enabled) and check status of the slave FrameScope
10 Activate the slave FrameScope if in idle mode
11 Authenticate the master FrameScope if the password is
enabled
12 Set up the slave FrameScope parameters by synchronizing
the master and slave FrameScope for the test
13 Start test
14 Query test results at end of test
15 Stop test
If the target selected is loopback device, all the test setup is
done in the master device. There will be no authentication
synchronization setup.
Setting the slave FrameScope for RFC 2544 Tests
1 From the Network main menu, press
System.