Filter
Top Products
Operation
Smart Distribution Panel with ATS 23
How to power the load from the generator
1. Place the ATS Automatic Operation switch in the
Disable position.
2. Ensure that the Source 2 switch on the ATS is OFF (
).
3. At the generator:
a. Place the
/Manual/Auto switch on the generator
control panel in the Manual position.
b. Press the Manual Run/Stop button on the generator
control panel, if you need to start the generator.
Pressing this button activates the engine control system
and the starting system. The starter will begin cranking
and, after a few seconds, the engine should start.
4. Turn the Source 1 switch on the ATS to OFF (
):
a. Set the selector switch on the Source 1 switch to
Manual.
The operating lever will swing out when the selector
switch is in Manual.
b. Turn the Source 1 switch to OFF (
). You can use the
operating lever key (provided), for easier operation.
Press