Filter
Top Products
Overview
16 Smart Distribution Panel with ATS
Automatic operation control panel
For a discussion of Automatic Operation of the InfraStruXure Power Generation System, see
“Automatic Operation” on page 19.
User connection plate
For a description and the location of the user connection plate, see number 2 on page 11. For clarity,
the user connection plate in the illustration below is turned upside-down from its factory-installed
position.
The Not in Automatic Operation
LED is lit when the ATS is NOT
in automatic operation, typically
when the automatic operation
switch is in the Disable position.
However, in rare instances, the
Not in Automatic Operation
LED can be lit when the automatic
operation switch is in the enable
position. See page 21 for more
information.
Select whether the generator will automatically turn on after a loss of power using the
Automatic Operation switch.
Connect the ATS to the network or the
InfraStruXure Manager through the
surge-protected ethernet port. This
port protects your network connection
from power surges.
The user connection plate has four input
contact connections for monitoring
Normally Open (NO) or Normally
Closed (NC) dry contacts. See page 46
and page 61 for more information.
The user connection plate has four relay
output connections for connection of
NO or NC dry contacts. See page 46 and
page 61 for more information.
Connect an Emergency Power-Off switch at one of three choices of EPO Connections
(24VDC, 24VAC, or contact closure). See page 63 for more information.