Filter
Top Products
Smart Distribution Panel with ATS 45
Config
System/Network
System/Network
Contacts & Relays
Sub-Feed Config.
Factory Defaults
Manufacturer Data
System ID
Firmware Updates
Electrical Config.
The following items are available on this menu:
System Password • Password: Change the system password required to access protected screens and
fields in the display interface. Enter a string of up to eight alphanumeric
characters, followed by the underline character (_) to indicate the end of the
string. The default password is apc.
• Timeout: Set the time that the display interface waits for user input before it
reverts to the initial scrolling of status screens. Select 1, 2, 5, 10 (the default) or
30 minutes; or 1, 2, or 4 hours, or forever.
• Invalidate NOW: Re-enter the system password for viewing password-protected
screens.
Date/Time • Date: Set in the following format: dd-mmm yyyy.
• Time: Set in the following format: hh:mm:ss
Local Interface • Contrast: Set the screen contrast for the LCD. Select from 1 (high contrast) to 8
(low contrast).
• Key Click: Choose On for an audible click whenever you press a navigation key.
Choose Off to disable the key click.
• Beeper Volume: Select High, Medium, Low, or Off to adjust the loudness of the
audible beeper and the key click.
• Metric Units: Choose On to view all data as metric values (e.g., meters) and Off
to view data as U.S. standard units (e.g., feet).
Network Config • IP: The system IP address.
• SM: The subnet mask, which identifies the subnetwork on which the ATS
operates.
• GW: The default gateway that the ATS uses.
The MAC address is displayed at the bottom of the screen in brackets.