Filter
Top Products
Customizing and Updating the ATS
72 Smart Distribution Panel with ATS
Installing breakers on the ATS panel board
This procedure shows the installation of the T1, three-pole breaker assembly on a 250A ATS panel
board. The steps are identical for installing the T1 single-pole and T3 three-pole breakers.
1. Attach the module to the ATS panel board
(
), and secure by turning the module locks using an
Allen key
(
).
2. Place the breakers onto the module’s bus bars
(
) and lock in place with an M4×70 screw (
).
Use a Phillips screwdriver to tighten.
3. Attach the breaker brackets to the slots in the distribution bus frame
(
), and secure using an
M6×12 Torx screw
(
). Use a T25 Torx driver to tighten. Attach the breaker to the breaker
bracket using an M4×70 screw
(
). Use a Phillips screwdriver to tighten.