Filter
Top Products
Smart Distribution Panel with ATS 51
Configuring the ATS Network Management
Interface
Connect the ATS to your network
1. Connect a Cat-5 network cable to the surge-protected ethernet port on the ATS user connection
plate. The arrow in the illustration below is pointing to the port. The figure on page 11 shows
the location of the user connection plate on the roof of the ATS.
You can make connections from inside the enclosure, or
you can remove the user connection plate and make your
connections. Remove the plate using a Phillips or standard
screwdriver to loosen the two captive screws. Use the
knockout in the plate to route cables to and from the user
connections on the plate. If you remove the plate, make
sure that you do not disturb the existing connections.
2. Run the connected Cat-5 network cable through a knockout in the user connection plate to your
network connection.
3. Configure the TCP/IP settings of the ATS. See “Configuration overview” on page 52 for further
instructions.