Filter
Top Products
Smart Distribution Panel with ATS 57
How to Access the ATS Network
Management Interface
Web interface
As your browser, you can use Microsoft
®
Internet Explorer 5.0 (and higher) or Netscape
®
4.0.8 (and
higher, except Netscape 6.x) to access the ATS through its Web interface. Other commonly available
browsers also may work but have not been fully tested by APC.
To use the Web browser to configure ATS options or to view the event log, you can use either of the
following:
• The HTTP protocol (enabled by default), which provides authentication by user name and
password but no encryption.
• The more secure HTTPS protocol, which provides extra security through Secure Socket Layer
(SSL) and encrypts user names, passwords, and data being transmitted. It also provides
authentication of Network Management Cards by means of digital certificates.
To access the Web interface and configure the security of your device on the network:
1.Address the ATS by its IP address or DNS name (if configured).
2.Enter the user name and password (by default, apc and apc for an Administrator, or device and
apc for a Device Manager).
3.Select and configure the type of security you want. (This option is available only for
Administrators.)
Note
The procedures in this section apply if you want to access the ATS from the public
LAN. If you want to access the ATS through the APC LAN, see the InfraStruXure
Manager’s Installation and Quick-Start manual for information.
See also
See the chapter entitled “Security” in the InfraStruXure Power Generation
System’s online Network Management User’s Guide for information on choosing
and setting up your network security. Use the Web/SSL option of the Network
menu to enable or disable the HTTP or HTTPS protocols.