Filter
Top Products
22
Connecting Share-UPS
continued
Connection
procedure,
continued
6 Connect the master server to port 1, the Advanced
port of Share-UPS, using the smart-signaling cable
(940-0024) supplied with your UPS. (See “Master
server versus other servers” on page 11.)
Note
: A server not supported by PowerChute plus
must use simple signaling with the appropri-
ate cable. (See “Choosing simple signaling
cables: Table 1” on page 4.)
If an accessory, such as Measure-
UPS II or
an Expansion Chassis
, is already using the
(Advanced) Computer Interface port of the
UPS
, connect the master server to the
UPS
Monitoring port on the accessory. (Accesso-
ries label this port in different ways, but the
function—replicating the Computer Inter-
face port of the
UPS
—is the same.)
7 Connect the other server(s) to the Basic ports on
Share-UPS, using
APC
cables. See “Choosing
simple signaling cables: Table 1” on page 4.
Note
: Servers connected to the Basic ports of
Share-UPS use simple signaling for moni-
toring the UPS. If these servers use
PowerChute plus, this software must be
configured for simple signaling. See “Con-
figuring PowerChute plus for simple
signaling” on page 12.
After
connecting
Share-UPS
After you have completed the connection procedure, con-
tinue with “Configuring Share-UPS” on page 23.