Filter
Top Products
Configuring for Management
Page 2-9
address when it is connected to the network and is powered
on, if your network contains a BootP server configured with
available, valid IP addresses.
▲ Important! BootP configuration only works if
the IntraSwitch does not have an IP address
assigned to it.
1
Make sure your network has a BootP server con-
figured with a valid IP address entry for the
IntraSwitch.
2
When the IntraSwitch is connected to the net-
work and is powered on, it automatically trans-
mits a BootP request across the network (up to
10 times) until it receives a valid IP address from
the BootP server.
3
After an IP address is received, the IntraSwitch
can be managed via in-band access. See Chapter
4 for more information.
To verify that a valid IP address was received, use a tool such as
Ping
1
to try and access the IntraSwitch; if you can access the
IntraSwitch, it is properly configured with an IP address.
See “Bootstrap Configuration” in Chapter 5 for more
information on using BootP.
Console
Configuration
To manually configure the IntraSwitch with an IP address via its
Console port, use a VT100 terminal or emulator (such as Hyper
Terminal, ProComm, or ZTerm) running on a workstation or
personal computer to connect to the switch’s Local Manage-
ment Interface.
1. Ping is an application that can be used to test whether a remote device is
properly connected to a network.
6216M Book Page 9 Wednesday, January 27, 1999 5:26 PM