Filter
Top Products
Bootstrap Configuration
Page 5-13
Figure 5-6 BootStrap Configuration Menu
▲ Important! The IntraSwitch’s default Load
Mode setting is Local.
When the IntraSwitch is powered on, it loads its software via
one of two methods: locally (via its internal flash memory
which is the default setting) or remotely over the network.
Image Banks
The IntraSwitch has two banks to store its run time software.
The banks are referred to as bank 1 and bank 2.
Either of these banks may be the Boot Bank, which is the bank
where the runtime code will be loaded the next time the
IntraSwitch is booted.
When downloading new runtime image codes, the user may
specify either of the two banks as the Destination Bank in
which the new code will be loaded.
Current Settings
6216M Book Page 13 Wednesday, January 27, 1999 5:26 PM