Filter
Top Products
11
5250 REMOTE EMULATOR CARD
2. Quick Setup Guide
Thank you for buying the 5250 Remote Emulator Card. If you are familiar
with emulation equipment, this chapter is designed to help you get up and
running in a short amount of time. It describes how to do the hardware
installation, software installation, and configuration setup in just a few steps
each.
CAUTION!
The 5250 Remote Emulator Card is a static-sensitive device. Keep the
Card in its protective bag until you are ready to install it.
2.1 Unpacking
Check the package your Card was shipped in for water-related or shipping-
related damage; contact the carrier if you find any. The package should
contain the following:
• (1) 5250 Remote Emulator Card
• (1) 3.5" software diskette
• (1) copy of this manual
Keep the original packaging in case you ever have to reship the card. If
your system requires 5
1
⁄4" diskettes, contact your supplier.
2.2 Installing the Hardware
1. Turn OFF the PC and any peripherals that might be attached to it.
Unplug the PC’s power cord or power supply from the electrical
outlet and (if possible) from the PC.
CAUTION!
Make sure that the PC is OFF and its power supply is unplugged and (if
possible) its power cord removed before you begin installing the Card
or connecting any of its cables. Don’t turn the PC back ON until you
have completely finished installing the Card and connecting all of its
cables.