Filter
Top Products
33
5250 REMOTE EMULATOR CARD
emulation choice for each cable address matches the device that the
system operator has configured the host to expect.
• Printer Type: When you move the cursor to this column, a menu
window listing the possible printer types appears. If the printer
connected to the PC is not listed, a printer definition can be created by
selecting Other
, typing a new name, and then defining the printer as
discussed in Section 6.3.3—select Printer Commands Definition
under
the Printer-Setup Menu and follow the instructions on page 43.
• PC Port: Select the PC port to which the printer is physically attached.
Choose an “LPT” port for parallel printers or a “COM” port for serial
printers. Move the cursor to the PC Port column, and a window
appears with the following choices: LPT 1
, LPT 2, LPT 3, COM 1, or
COM 2
. If you choose a “COM” port for serial printers, a second
window will appear on the screen to define communications protocol
for data rate, data bits, stop bits, and parity.
6.2.2 B
ASIC
S
ETUP
Basic Setup options are for configuring the PC in typical applications. At
the Configuration Menu, move the cursor to Basic Setup
and press
[ENTER]. The Basic Setup Menu appears, as shown below in Figure 6-4.
Figure 6-4. The Basic Setup Menu.
Menu
Change Previous Screen
Modify / Create /Delete / Exit File Name = EM5251R
Setup Options
Monitor Type Monochrome Color Color
(IBM)
Emulator Startup 3X Emulation DOS
PC Keyboard AT PC/XT Enhanced
Emulated 5250 PC
Keyboard
Key Click Off On
File Transfer No Yes
Virtual Disk ABCD
Direct Hot Key On Off
Select type of monitor connected to PC