Black Box 5250 Computer Hardware User Manual


 
27
5250 REMOTE EMULATOR CARD
10. From the File menu, select New.
11. Select PPrrooggrraamm IItteemm.
12. For the description, type RCONFIG.
13. For the command line, type C:\5251R\RCONFIG.PIF.
14. Select CChhaannggee IIccoonn.
15. For the icon name, type C:\5251R\RCONFIG.ICO.
16. To save and exit, click on OOKK twice.
You are now ready to begin configuration; follow the instructions in the
next chapter. Be sure to change the hotkey code under the Keyboard
Setup option (see Section 6.3.2). For hints about operating the Card
under Windows, see Section 7.2.
5.3 Installation with PC Support
5.3.1 PC S
UPPORT
/38
To install IBM PC Support/38, follow the installation instructions in its
technical reference manual, IBM Enhanced Emulation. Before you install
the emulation software, configure the 5250 Remote Emulator Card
(see Chapter 6). When you do this, set the virtual disk drive to your
diskette drive and set the emulator startup to DOS (see Section 6.2.2).
Install the emulation software when you’re ready to start emulation
(see Section 7.1.3 for full instructions).
5.3.2 PC S
UPPORT
/36
To install IBM PC Support/36, follow the installation instructions in its
user’s guide. During the installation, when you are asked for the type
of emulation program, specify “Other” and enter the name of the
5250 Remote Emulator Card’s emulation program, EM5251R.EXE.
PC Support/36 takes over from there; no further software installation
is necessary.
You are now ready to begin configuration; follow the instructions in the
next chapter. Be sure to change the hotkey code under the Keyboard
Setup option (see Section 6.3.2).