Black Box 5250 Computer Hardware User Manual


 
8
5250 REMOTE EMULATOR CARD
1. Specifications
System Hardware
Requirements — PC: IBM PC, PC/XT, AT, or 100% compatible w/ free
16-bit ISA- or EISA-bus slot and 3.5" diskette drive;
Host: IBM System/3X or AS/400 with an available
synchronous communications port that supports
the SDLC protocol;
DCE (for remote operation only): (1) Pair of sync
modems with appropriate DTE-to-DCE cables
System Software
Requirements — PC: DOS 3.3 or higher;
System/34 Host: System/34 release 9.0;
System/36 Host: System/36 release 5.1 or higher;
System/38 Host: System/38 release 8.0 or higher;
AS/400 Host: OS/400 V2R0 or higher
System Memory
Requirements — PC: 225 KB + 11 KB per display session + 29 KB
per printer session; might require an additional
16 KB to save 132-column graphic screens when
hotkeying between host and DOS sessions
Bus — 16-bit ISA or EISA; not compatible with
Micro Channel Architecture (MCA)
Address Used — Either 300 to 30F, 310 to 31F, 320 to 32F, 340 to 34F,
350 to 35F, 360 to 36F, 380 to 38F, or 3A0 to 3AF
(user-selectable)
Interrupts Used — Either IRQ3, IRQ4, IRQ10, IRQ11, or IRQ15 (user-
selectable)
Cable Required — For local operation:
(1) 20-ft. (6.1-m) cross-pinned adapter cable:
Under EIA RS-232D/CCITT V.24: (1) DB44 male
to DB25 female (EHN064-0020);
Under CCITT X.21: (1) DB44 male to DB15
female (EHN063-0020);
Under CCITT V.35: (1) DB44 male to 34-pin
M-block male (EHN065-0020);
For remote operation:
(1) 20-ft. (6.1-m) straight-thru-pinned adapter cable:
Under EIA RS-232D/CCITT V.24: (1) DB44 male
to DB25 female (EHN061-0020);