Filter
Top Products
INTEGRUS | Installation and User Instructions | Integrus Transmitters en | 17
Bosch Security Systems | 2005-04 | 3122 475 22015en
2.2.2 Mounting an interface module in the
transmitter housing
Follow the instructions below to mount an interface
module in the transmitter housing. The numbers refer
to figure 2.5 and figure 2.6.
1. Remove the top cover of the transmitter housing.
2. Remove the interface module slot cover (1) at the
back of the transmitter. Keep the screws (2).
3. Insert the module (3) (with the components faced
down) into the transmitter housing and push it firm-
ly into the PCB connector (4).
4. Fasten the slot cover (5) to the back of the transmit-
ter housing. Use the screws (2) from step 2.
5. Fasten the module’s PCB to the distance studs (6).
Use the screws (7) provided with the interface
module.
6. Close the transmitter housing.
Warning: To prevent damage to the PCB
connectors (4), be sure that the connec-
tors are aligned properly before pushing
the module in.
1
2
Figure 2.5 Interface module slot cover
Figure 2.6 Mounting an interface module in the transmitter
housing
3
2
7
5
4
6
Warning: Before opening the transmitter
housing, make sure that the mains
power and all other connections are
disconnected!
Warning: ICs and many other electronic
components are susceptible to electrostatic
discharge (ESD). Take preventive measures
when handling the interface modules. Keep
the PCBs as long as possible in their pro-
tective packing. Wear an anti-ESD bracelet.