Filter
Top Products
INTEGRUS | Installation and User Instructions | Integrus Radiators en | 46
Bosch Security Systems | 2005-04 | 3122 475 22015en
3.1.5 Using the output power selection
switch
The radiators can be switched to half power. This can
be used when full power is not required, e.g. when a
mobile system is used in a small conference venue.
Also switch a radiator to half power when an adequate
air flow can not be guaranteed, e.g. when the radiator
is mounted on top of an interpreters booth. Reducing
the power when possible saves energy and increases
the lifetime.
3.2
Low Power Wide Beam Radiator
3.2.1 Description
This radiator is designed for small or medium-sized
conference venues. The radiator has an infra-red out-
put of 3 Wpp and they have a built-in power supply
and are switched on automatically when the transmitter
is switched on. A mains cable is provided. When not
receiving carrier waves, the radiators switch to standby
mode. They can be mounted on walls and ceilings or
on a floor stand. Figures 3.11 and 3.12 show front and
rear views of the radiators.
Figure 3.11 LBB 3410/05 Radiator (Front view)
Figure 3.12 LBB 3410/05 Radiator (Rear view)
1. Male mains connector - for connecting the radia-
tor to the mains supply.
2. HF BNC input and output connectors - for con-
necting the radiator to the transmitter or for loop-
through connection to other radiators.
3. Power reduction switch - reduces the output
power of the radiator to 1.5 Wpp.
4. Radiator mounting bracket.
Figure 3.10 Loop-through connection of radiators
2
4
1
3
2