Filter
Top Products
INTEGRUS | Installation and User Instructions | Integrus Transmitters en | 32
Bosch Security Systems | 2005-04 | 3122 475 22015en
2.5.5 Set monitoring options
The Monitoring sub-menu (2) is used to set which sig-
nal is sent to the monitoring headphone output. It can
be one of the inputs, one of the channels or no signal.
When the sensitivity of one of the inputs is being
changed in the Setup menu (4J, 4K or 4L), or when
assigning inputs to channels (menu 4D, Per Channel),
the monitoring output automatically switches temporar-
ily to that source, even when the option ‘None’ has
been chosen.
When the headphone output is disabled (see section
2.5.18), the output level can not be changed and the
level indicator is not visible.
Menu Item Option Value 1 Value 2 Description
2A Source/Volume S
ource;
- In. nn Input nr: Volume: The signal from audio input nn is available
00 ... 31 -31 ... 0 dB on the monitoring headphone output.
- Ch. nn
Channel
nr: Volume:
The signal on channel nn
is available on the
00 ...31 -31 ... 0 dB monitoring headphone output.
- Aux.L V
olume:
The signal on the Aux. Left input is available on
-31 ... 0 dB the monitoring headphone output.
- Aux.R V
olume:
The signal on the Aux. Right input is available
-31 ... 0 dB on the monitoring headphone output.
- None V
olume:
The monitoring headphone output is switched off
-31 ... 0 dB during normal operation, but is active when the
sensitivity of one of the inputs is being changed.
The ‘Source/volume’ screen also displays level meters (two
for a stereo source, one for a mono source) for a visual indi-
cation of the actual signal strength: ■ = low level,
■
= high
level, ▲ = overflow.
Menu Item Value (read only) Description
3A Serial Number e.g. 19.0.00001 Shows the serial number of the transmitter board.
3B HW Version e.g. 01.00 Shows the version number of the transmitter board.
3C FPGA Version e.g. 2.00.00 Shows the version number of the FPGA software of the
transmitter board.
3D FW Version e.g. 1.00.0001 Shows the version number of the transmitter firmware.
2.5.6 View version information
In the Enquiry sub-menu (3), version information of
the transmitter can be found. This information should
be mentioned in service requests or failure reports.