Filter
Top Products
INTEGRUS | Installation and User Instructions | Integrus Transmitters en | 22
Bosch Security Systems | 2005-04 | 3122 475 22015en
2.3.4 Connecting an emergency signal
To use the emergency signal function, a switch (nor-
mally-open) must be connected to the emergency
switch connector. The reaction of the transmitter on a
closed switch depends on the configuration of the aux-
iliary inputs (see also section 2.5.14):
• If the auxiliary input is 'Mono + Emergency', the
audio signal on the Aux-Right input is distributed
to all output channels, overriding all other audio
inputs.
• If the auxiliary input is 'Stereo' or 'Stereo to Mono',
the audio signals on the Aux-Left and Aux-Right
inputs are distributed to all output channels, over-
riding all other audio inputs.
2.3.5 Connecting to another transmitter
The transmitter can be operated in slave mode to loop-
through the IR radiator signals from a master transmit-
ter. One of the four radiator outputs of the master
transmitter is connected with an RG59 cable to the
radiator signal loop-through input of the slave transmit-
ter.
The Transmission mode of the slave transmitter must
be set to ‘Slave’ (see section 2.5.7).
1
2
3
4
5
6
1
2
3
4
5
6
1
2
N
etw
or
k
Figure 2.13 Connecting external audio sources to the
Modular IR transmitter
1
2
3
4
5
6
1
2
3
4
5
6
1
2
N
e
t
w
o
r
k
Figure 2.14 Connecting an emergency signal
1
2
3
4
5
6
1
2
3
4
5
6
MASTER SLAVE
1
2
3
4
5
6
1
2
N
e
t
w
o
rk
1
2
3
4
5
6
1
2
N
e
t
w
o
r
k
Figure 2.15 Connecting to another transmitter
Note: When the network mode is enabled
(see section 2.5.8), the emergency signal
function is not available when the control
unit of the DCN Next Generation confer-
ence system is switched off or defective.