Filter
Top Products
INTEGRUS | Installation and User Instructions | Integrus Transmitters en | 20
Bosch Security Systems | 2005-04 | 3122 475 22015en
9. On the new main PCB (2) fasten the flexible cables
(18) to the analogue input/output PCB. To this end
release the catches (19) on both sides and insert the
flexible cable.
10. If the transmitter contained an interface module
(20): Mount the interface module proceeding as
described in section 2.2.2.
11. If the transmitter did not contain an interface
module: Mount the interface module slot cover on
the new rear panel.
12. Mount the top cover of the transmitter housing.
Note: Make sure that the flexible cables
are entirely and correctly inserted into the
connector as incorrect mounting will lead
to transmitter failure.
See inset in figure 2.10.
Figure 2.9 Installation of the INT-TXK (steps 1 - 6)
2
5C
8
1
1
10
11
9
6
4
3
5B 5A
7
18
20
2
14
13
16
17
12
12
12A
12C
18 18
18
12B
15
19
Figure 2.10 Installation of the INT-TXK (steps 7 - 12)